Dynalab Test Systems - Wire Harness Testing Equipment Accessories, Cable Tester Accessories, Continuity Test Equipment Accessories

Discrete Wire

NX Tester Test Point Boards are divided into two sets of 64 points, each designed to mate with a 64 pin card edge connector. Dynalab uses card edge connections, rather than fine pitch, pin-type connectors, for durability and ease of use. A wide range of interface cables are offered to attach a Dynalab NX Tester to your test fixture.

Discrete Wire Interface Cable

The Discrete Wire Interface Cable is the most commonly used interface cable. Its 64 individual 24 AWG wires are cut to length - ready to be attached to a fixture. This cable interfaces any Dynalab Tester and is available in two lengths.


5-2006	Discrete Wire Interface Cable, 6'
5-2012	Discrete Wire Interface Cable, 12'
5-2018	Discrete Wire Interface Cable, 18'

Discrete Wire Connector

To create custom interface cables, Dynalab offers the connector used to build the Discrete Wire Interface Cable.
Note: Special crimping is required to attach wires to this connector.


5-2091	Card Edge Connector